南宁附近有没有服务

 Milton law metering pump agent

    Product search
    Product Name:
    Product price: reach
    More > > contact us

    Henan Qingshi environmental protection equipment Co., Ltd

    Contact: Mr. Duan

    Tel: 18037579877

    Address: no.1601, building 9, No.220 Jinsuo Road, high tech Zone, Zhengzhou, Henan Province

    Engineering Department 1: Wang Gong

    Tel: 19939136330

    Engineering Department 2: Sun Gong

    Tel: 15037255

    Precautions for mixer

    Release time: 2020 / 9 / 17 10:12:52 Author: Henan Qingshi environmental protection equipment Co., Ltd

    Start up preparation:

    edit


    1. Preparation before start-up: check whether there are sundries in the disk, check whether the bolts in each part are loose, whether the oil of reducer is sufficient, whether the scraper is loose, whether the angle is correct, whether the power supply and whether the wire leakage.

    2. Start the machine to clear all materials in the disk, and ensure that the power supply is started again when it is empty. Start the machine and listen to whether there is abnormal sound, and feed in strict accordance with the regulations.
    3. Stop the machine and clean up the remaining materials after the materials in the plate are discharged

    matters needing attention:


    (1) The mixer should be set in a flat position, and the front and rear axles should be padded with square wood to make the tires empty so as to avoid walking when starting.

    (2) The mixer shall be provided with secondary leakage protection. After the power supply is connected before going to work, it must be checked carefully and can be used only after passing the test run of empty car. In case of large difference between the speed of mixing wheel (3) and that of the driving wheel (3), it is necessary to check whether the speed of the driving wheel is slightly different from that of the driving wheel in case of large difference between the speed of the driving wheel and that of the driving wheel.
    (3) The rotation direction of mixing drum shall conform to the direction indicated by the arrow. If not, the motor wiring shall be corrected.
    (4) Check whether the transmission clutch and brake are flexible and reliable, whether the wire rope is damaged, whether the track pulley is in good condition, whether there are obstacles around and the lubrication of various parts.
    (5) After starting the machine, always pay attention to the normal operation of each part of the mixer. When stopping the machine, check whether the blades of the mixer are bent and whether the screws are broken or loose.
    (6) When the concrete mixing is completed or it is expected to stop for more than 1 h, in addition to discharging the remaining materials, stones and clean water shall be poured into the shaking drum, and the machine shall be started to rotate, and the mortar adhered to the barrel shall be washed and discharged completely. There should be no water in the barrel to avoid rust of the barrel and blade. At the same time, the ash accumulation outside the mixing drum should be cleaned to keep the machinery clean and intact.
    (7) After work and when the machine is not in use, the switch should be switched off and the switch box should be locked to ensure safety.


    Share with:
    more...

    Previous: Classification of pH meters
    Next: Selection table of Milton roe electromagnetic metering pump